Materials and processes issues in fine pitch eutectic solder flip chip interconnection Changqing Liu M.W. Hendriksen David Hutt Paul Conway David Whalley 2134/3789 https://repository.lboro.ac.uk/articles/journal_contribution/Materials_and_processes_issues_in_fine_pitch_eutectic_solder_flip_chip_interconnection/9574007 New product designs within the electronics packaging industry continue to demand interconnects at shrinking geometry, both at the integrated circuit and supporting circuit board substrate level, thereby creating numerous manufacturing challenges. Flip chip on board (FCOB) applications are currently being driven by the need for reduced manufacturing costs and higher volume robust production capability. One of today’s low cost FCOB solutions has emerged as an extension of the existing infrastructure for surface mount technology and combines an under bump metallization (UBM) with a stencil printing solder bumping process, to generate mechanically robust joint structures with low electrical resistance between chip and board. Although electroless Ni plating of the UBM, and stencil printing for solder paste deposition have been widely used in commercial industrial applications, there still exists a number of technical issues related to these materials and processes as the joint geometry is further reduced. This paper reports on trials with electroless Ni plating and stencil paste printing and the correlation between process variables in the formation of bumps and the shear strength of said bumps at different geometries. The effect of precise control of tolerances in squeegees, stencils and wafer fixtures was examined to enable the optimization of the materials, processes, and tooling for reduction of bumping defects. 2008-10-22 13:59:18 Flip-chip Shear Strength Stencil Printing Under Bump Metalization Mechanical Engineering not elsewhere classified