%0 Conference Paper %A Kaijuka, Precious %A Dixon, Roger %A Ward, Christopher %D 2018 %T Active fault tolerant control applied to REPOINT, a novel railway track switch %U https://repository.lboro.ac.uk/articles/conference_contribution/Active_fault_tolerant_control_applied_to_REPOINT_a_novel_railway_track_switch/9575165 %2 https://repository.lboro.ac.uk/ndownloader/files/17209280 %K Fault accommodation %K Reconfiguration strategy %K Applications and fault tolerant control %K Reconfigurable control %K Mechanical Engineering not elsewhere classified %X Railway networks are fitted with switches and crossings that enable trains to move from one track to another however they present a single point of failure. Existing track switches actuation is performed in the open loop presenting a research gap where closed-loop fault tolerant control can be applied to track switch actuation in order to improve railway network performance. A new railway track switch, REPOINT has been developed at Loughborough University with a new electromechanical design that incorporates actuator redundancy to improve the reliability of track switch operation. This paper looks at the development and validation of a sensor fault detection, identfication and accomodation scheme applied to a detailed non-linear model representing the laboratory scale demonstrator of the REPOINT concept. A residual-based fault diagnosis scheme is developed from the comparison of estimates generated by a bank of observers and output measurements. In the presence of sensor faults, a reconstructed signal from the fault detection algorithm is used to replace the measured signal for feedback control and thus safe switching position control is achieved. The results demonstrate that using a reliable fault tolerant control configuration could increase the availability and reliability of the REPOINT track switch. %I Loughborough University