sensors-16-02011.pdf (5.99 MB)
0/0

Anatomical calibration through post-processing of standard motion tests data

Download (5.99 MB)
journal contribution
posted on 06.01.2017 by Weisheng Kong, Salvatore Sessa, Massimiliano Zecca, Atsuo Takanishi
The inertial measurement unit is popularly used as a wearable and flexible tool for human motion tracking. Sensor-to-body alignment, or anatomical calibration (AC), is fundamental to improve accuracy and reliability. Current AC methods either require extra movements or are limited to specific joints. In this research, the authors propose a novel method to achieve AC from standard motion tests (such as walking, or sit-to-stand), and compare the results with the AC obtained from specially designed movements. The proposed method uses the limited acceleration range on medial-lateral direction, and applies principal component analysis to estimate the sagittal plane, while the vertical direction is estimated from acceleration during quiet stance. The results show a good correlation between the two sets of IMUs placed on frontal/back and lateral sides of head, trunk and lower limbs. Moreover, repeatability and convergence were verified. The AC obtained from sit-to-stand and walking achieved similar results as the movements specifically designed for upper and lower body AC, respectively, except for the feet. Therefore, the experiments without AC performed can be recovered through post-processing on the walking and sit-to-stand data. Moreover, extra movements for AC can be avoided during the experiment and instead achieved through the proposed method.

Funding

This research has been supported by the JSPS Grant-in-Aid for Young Scientists (Wakate B) [15K21437] and FY2016 Grant Program for Promotion of International Joint Research of Waseda University. The present work was also supported in part by the Program for Leading Graduate Schools, Graduate Program for Embodiment Informatics of the Ministry of Education, Culture, Sports, Science and Technology. Partial support was also obtained from the UK HEFCE Catalyst grant and from the WSMEME startup grant.

History

School

  • Mechanical, Electrical and Manufacturing Engineering

Published in

Sensors (Switzerland)

Volume

16

Issue

12

Citation

KONG, W. ... et al, 2016. Anatomical calibration through post-processing of standard motion tests data. Sensors, 16 (12), s16122011.

Publisher

MDPI / © The Authors

Version

VoR (Version of Record)

Publisher statement

This work is made available according to the conditions of the Creative Commons Attribution 4.0 International (CC BY 4.0) licence. Full details of this licence are available at: http://creativecommons.org/licenses/ by/4.0/

Acceptance date

23/11/2016

Publication date

2016-11-28

Copyright date

2016

Notes

This is an Open Access article published by MDPI and distributed under the terms of the Creative Commons Attribution Licence (CC BY 4.0), http://creativecommons.org/licenses/by/4.0/

ISSN

1424-8220

Language

en

Licence

Exports