Passmore 1.pdf (224.94 kB)
Design methodology and performance of an indraft wind tunnel
journal contribution
posted on 2010-09-29, 14:37 authored by G. Johl, Martin Passmore, Peter RenderThe design methodology and performance of Loughborough University’s new 1·9m × 1·3m, indraft wind tunnel is discussed in the following paper. To overcome severe spatial and financial constraints, a novel configuration was employed, with the inlet and exit placed adjacent to each other and opened to atmosphere. Using a fine filter
mesh, honeycomb, two turbulence reduction screens and a contraction ratio of 7·3, flow uniformity in the working area of the jet at
40ms-1 is shown to be within 0·3% deviation from the mean velocity, with turbulence intensity in the region of 0·15%. Working section boundary layer characteristics are shown to be consistent with that of a turbulent boundary layer growing along a flat plate, which originates at the point of inflection of the contraction. A maximum velocity of 46ms-1 was achieved from a 140kW motor, compared to a prediction of 44ms-1, giving an energy ratio of 1·42. Comparison
between theoretical and measured performance metrics indicate differences between the way modules perform when part of a wind
tunnel system compared to data gathered from test rigs.
History
School
- Aeronautical, Automotive, Chemical and Materials Engineering
Department
- Aeronautical and Automotive Engineering
Citation
JOHL, G., PASSMORE, M.A. and RENDER, P.M., 2004. Design methodology and performance of an indraft wind tunnel. The Aeronautical Journal, 108 (1087), pp. 465-473.Publisher
© Royal Aeronautical SocietyVersion
- VoR (Version of Record)
Publication date
2004ISSN
0001-9240Publisher version
Language
- en