Accurate characterisation of hole geometries by fringe projection profilometry
conference contributionposted on 08.08.2017 by Yuxiang Wu, Harshana Dantanarayana, Huimin Yue, Jonathan Huntley
Any type of content contributed to an academic conference, such as papers, presentations, lectures or proceedings.
Accurate localisation and characterisation of holes is often required in the field of automated assembly and quality control. Compared to time consuming coordinate measuring machines (CMM), fringe-projection-based 3D scanners offer an attractive alternative as a fast, non-contact measurement technique that provides a dense 3D point cloud of a large sample in a few seconds. However, as we show in this paper, measurement artefacts occur at such hole edges, which can introduce errors in the estimated hole diameter by well over 0.25 mm, even though the estimated hole centre locations are largely unaffected. A compensation technique to suppress these measurement artefacts has been developed, by modelling the artefact using data extrapolated from neighboring pixels. By further incorporating a sub-pixel edge detection technique, we have been able to reduce the root mean square (RMS) diameter errors by up to 9.3 times using the proposed combined method.
This work was supported by the Engineering and Physical Sciences Research Council under the Light Controlled Factory project EP/K018124/1.
- Mechanical, Electrical and Manufacturing Engineering