Mohammadpour et al.pdf (1.79 MB)
0/0

A new designed incremental high pressure torsion process for producing long nanostructured rod samples

Download (1.79 MB)
journal contribution
posted on 10.11.2016 by Mehdi Eskandarzade, Abolfazl Masoumi, Ghader Faraji, Mahdi Mohammadpour, Sabrina Yan
High pressure torsion (HPT) is one of the most important and effective severe plastic deformation (SPD) processes for producing nanostructured (NS) and ultrafine grained (UFG) metals. Whereas HPT presents excellent mechanical properties, its applications are limited to small disk-shaped samples. In this study a new design of incremental HPT (IHPT) process entitled SIHPT is developed which is much convenient for the production of large NS and UFG metallic rods. In this new design, some steppers along the length of the rod-shaped sample are used while applying an axial load from two ends of it. Step twisting of stepper parts with simultaneous axial loads extend the deformed region to the whole length of the sample. The five turn IHPT process was applied to a 50 mm length and 10 mm diameter pure copper sample and microstructure, and mechanical properties were evaluated. The microstructural study of SIHPT processed samples using TEM and EBSD micrographs clearly reflected the NS sample having an average grain size of less than 100 nm. Also, microhardness measurements showed that the sample has fairly good homogeneity through both axial and radial directions. Besides, tensile test measurements indicate that there is about four times improvement in yield strength of nanostructured sample compared to unprocessed metal which is accompanied with satisfactory ductility as a result of high hydrostatic compressive stresses.

History

School

  • Mechanical, Electrical and Manufacturing Engineering

Published in

Journal of Alloys and Compounds

Citation

ESKANDARZADE, M. ... et al, 2016. A new designed incremental high pressure torsion process for producing long nanostructured rod samples. Journal of Alloys and Compounds, 695, pp. 1539-1546.

Publisher

© Elsevier

Version

AM (Accepted Manuscript)

Publisher statement

This work is made available according to the conditions of the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International (CC BY-NC-ND 4.0) licence. Full details of this licence are available at: https://creativecommons.org/licenses/by-nc-nd/4.0/

Acceptance date

28/10/2016

Publication date

2016

Notes

This paper was accepted for publication in the journal Journal of Alloys and Compounds and the definitive published version is available at http://dx.doi.org/10.1016/j.jallcom.2016.10.296.

ISSN

0925-8388

Language

en

Exports