1/1
0/0

A technique for fabricating patterns for removable partial denture frameworks using digitized casts and electronic surveying

journal contribution
posted on 09.04.2014 by R.J. Williams, Richard Bibb, Tahseen A. Rafik
Although computer-aided design and manufacture techniques have shown some promising applications in the fabrication of crowns, inlays, and maxillofacial and oral surgery, the field of removable prosthodontics has not embraced these technologies so far. This article describes the development and investigation of computer-aided techniques that may eventually enable prosthodontic procedures such as surveying and the production of sacrificial patterns to be performed digitally. A 3-dimensional computer model of a conventional cast from a patient was obtained using an optical surface capture device (a scanner). The shape of a number of components of a removable partial denture framework was modeled on the 3-dimensional scan electronically, using computer-aided design software. A physical plastic shape of the components was produced using a Rapid Prototyping machine and used as a sacrificial pattern. Techniques to allow digital cast surveying before the production of sacrificial patterns were also developed. The results show that digital dental surveying and machine-produced sacrificial patterns can be accomplished. This article forms a basis for further developments leading to a fully integrated approach to the computer-aided design and fabrication of removable partial denture frameworks.

History

School

  • Design

Citation

WILLIAMS, R.J., BIBB, R.J. and RAFIK, T., 2004. A technique for fabricating patterns for removable partial denture frameworks using digitized casts and electronic surveying. Journal of Prosthetic Dentistry, 91 (1), pp.85-88.

Publisher

© Elsevier

Version

AM (Accepted Manuscript)

Publication date

2004

Notes

This is the author’s version of a work that was accepted for publication in The Journal of Prosthetic Dentistry. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published at: http://dx.doi.org/10.1016/j.prosdent.2003.10.002

ISSN

0022-3913

Language

en

Exports

Logo branding

Keyword(s)

Exports