3D printing ceramic cores for investment casting of turbine blades, using LCD screen printers: The mixture design and characterisation

The primary objective of this study is to demonstrate the possibility of developing silica, alumina, and zircon-based photocurable ceramic suspensions that can be used for visible light photopolymerization (> 450 nm) and to optimise the binder formulations for the purpose of LCD-based ceramic 3D printing applications. Reference ceramic components for this work are ceramic cores employed in the investment casting of high-pressure turbine blades and vanes. Arguably, one of the most critical steps in photoinduced ceramic 3D printing is developing suitable ceramic suspensions, having high ceramic loading, low viscosity, and short curing times. Ceramic suspensions with four different novel binder formulations and commercial ceramic powders used in core manufacturing (SiO2, Al2O3 and ZrSiO4) were investigated to achieve the best trade-off between: (1) their curing performance (cure depth and curing speed), (2) rheological properties of the binder mixtures at the solid loadings of 60 vol.% for SiO2, 55 vol.% for ZrSiO4, and 45 vol.% for Al2O3; and (3) the green body mechanical properties of the mixtures after printing. The effect of ceramic particles on the selected binders was examined individually, and the correlation between cure depth (Cd), volumetric loading, and curing speed are evaluated. The results show all binders designed in this study provide an adequate cure depth, even at high ceramic loadings. When the curing behaviour of all unloaded binder mixtures from the previous study [1] compared with the 10 vol.% SiO2 loaded mixtures, the cure depth of all formulated binder mixtures increased 50-55% and the curing thickness of 60 vol.% SiO2 loaded suspensions were still slightly higher than their unloaded counterparts. The rheology outcomes indicate that lower viscosity binders always result in lower viscosity of the ceramic loaded inks, even without taking the effect of dispersants into account. Besides, the addition of N-Vinyl-2-Pyrrolidone (NVP) monofunctional monomer to the binder mixtures significantly reduces the viscosity and changes the normally linear relationship of the mix viscosity and its silica loading content. Among the binder formulations loaded with 60 vol.% of SiO2, the formulation providing the lowest viscosity and highest mechanical property consists of 5 wt.% of NVP, 45 wt.% of HDDA and 50 wt.% of Photocentric 34 resin. Although this binder mixture showed the highest green flexural strength when loaded by 55 vol.% ZrSiO4, all other mixtures loaded with zircon flour also demonstrated a near-fluid behaviour, below 200 s-1. In Al2O3 loaded mixtures, the HDDA di-functional binder formulations present lowest viscosity and the di- and multifunctional monomer blends (HDDA-Photocentric27) showed the highest mechanical properties when used in a 50/50 ratio. This work summarises the best binder choices for silica, alumina and zircon based ceramic suspensions used in core printing for investment casting applications through LCD screen printing.