Loughborough University
AMC slot.pdf (428.72 kB)

CPW-fed cavity-backed slot radiator loaded with an AMC reflector

Download (428.72 kB)
journal contribution
posted on 2012-06-26, 11:24 authored by J. Joubert, J. C. Vardaxoglou, William WhittowWilliam Whittow, J.W. Odendaal
A low profile coplanar waveguide (CPW) fed printed slot antenna is presented with uni-directional radiation properties. The slot antenna radiates above a closely spaced artificial magnetic conducting (AMC) reflector consisting of an array of rectangular patches, a substrate and an electric ground plane. The electromagnetic bandgap (EBG) performance of the cavity structure between the upper conducting surface in which the slot is etched, and the ground plane at the bottom of the reflector, is investigated using an equivalent waveguide feed in the place of a half-wavelength section of the slot antenna. Fromthe reflection coefficient of the equivalent waveguide feed one can determine the frequency band where minimum energy will be lost due to unwanted radiation from the cavity sides. The dimensions of the cavitywere found to be very important for minimum energy loss. Experimental results for the final antenna design (with a size of ), mounted on a back plate, exhibit a 5% impedance bandwidth, maximum gain in excess of 10 dBi, low cross-polarization, and a front-to-back ratio of approximately 25 dB. This low-profile antenna with relatively high gain could be a good candidate for a 2.4 GHz WLAN application.



  • Mechanical, Electrical and Manufacturing Engineering


JOUBERT, J. ... et al, 2012. CPW-fed cavity-backed slot radiator loaded with an AMC reflector. IEEE Transactions on Antennas and Propagation, 60 (2:2), pp. 735-742.




  • AM (Accepted Manuscript)

Publication date



This paper was accepted for publication in IEEE Transactions on Antennas and Propagation. The definitive version is available from: http://dx.doi.org/10.1109/TAP.2011.2173152




  • en