Gkinis_et_al_JZUS-A.pdf (819.53 kB)
Download file

Heat generation and transfer in automotive dry clutch engagement

Download (819.53 kB)
journal contribution
posted on 12.03.2018, 09:50 by Theofilos Gkinis, Ramin RahmaniRamin Rahmani, Homer Rahnejat, M. O'Mahony
Dynamic behaviour of automotive dry clutches depends on the frictional characteristics of the contact between the friction lining material, the flywheel and the pressure plate during the clutch engagement process. During engagement due to high interfacial slip and relatively high contact pressures, generated friction gives rise to contact heat, which affects the material behaviour and the associated frictional characteristics. In practice excess interfacial slipping and generated heat during torque transmission can result in wear of the lining, thermal distortion of the friction disc, and reduced useful life of the clutch. This paper provides measurement of friction lining characteristics for dry clutches for new and worn state under representative operating conditions pertaining to interfacial slipping during clutch engagement, applied contact pressures, and generated temperatures. An analytical thermal partitioning network model of the clutch assembly, incorporating the flywheel, friction lining, and the pressure plate is presented, based upon the principle of conservation of energy. The results of the analysis show a higher coefficient of friction for the new lining material which reduces the extent of interfacial slipping during clutch engagement, thus reducing the frictional power loss and generated interfacial heating. The generated heat is removed less efficiently from worn lining. This might be affected by different factors observed such as the reduced lining thickness and the reduction of density of the material but mainly because of poorer thermal conductivity due to the depletion of copper particles in its microstructure as the result of wear. The study integrates frictional characteristics, microstructural composition, mechanisms of heat generation, effect of lining wear and heat transfer in a fundamental manner, an approach not hitherto reported in literature.

History

School

  • Mechanical, Electrical and Manufacturing Engineering

Published in

Journal of Zhejiang University Science A

Volume

19

Issue

3

Pages

175 - 188

Citation

GKINIS, T. ...et al., 2018. Heat generation and transfer in automotive dry clutch engagement. Journal of Zhejiang University Science A, 19(3), pp. 175-188.

Publisher

© Zhejiang University and Springer-Verlag GmbH Germany

Version

AM (Accepted Manuscript)

Publisher statement

This work is made available according to the conditions of the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International (CC BY-NC-ND 4.0) licence. Full details of this licence are available at: https://creativecommons.org/licenses/by-nc-nd/4.0/

Acceptance date

25/01/2018

Publication date

2018

Notes

This is a post-peer-review, pre-copyedit version of an article published in Journal of Zhejiang University Science A. The final authenticated version is available online at: http://dx.doi.org/10.1631/jzus.A1700481.

ISSN

1673-565X

eISSN

1862-1775

Language

en