Reduced-order GPIO based dynamic event-triggered tracking control of a networked one-DOF link manipulator without velocity measurement
In networked robot manipulators that deeply integrate control, communication and computation, the controller design needs to take into consideration the limited or costly system resources and the presence of disturbances/uncertainties. To cope with these requirements, this paper proposes a novel dynamic event-triggered robust tracking control method for a one-degree of freedom (DOF) link manipulator with external disturbance and system uncertainties via a reduced-order generalized proportional-integral observer (GPIO) . By only using the sampled-data position signal, a new sampled-data robust output feedback tracking controller is proposed based on a reduced-order GPIO to attenuate the undesirable influence of the external disturbance and the system uncertainties. To save the communication resources, we propose a discrete-time dynamic event-triggering mechanism (DETM) , where the estimates and the control signal are transmitted and computed only when the proposed discrete-time DETM is violated. It is shown that with the proposed control method, both tracking control properties and communication properties can be significantly improved. Finally, simulation results are shown to demonstrate the feasibility and efficacy of the proposed control approach.
Funding
Research on Several Problems of Non-smooth Control System
National Natural Science Foundation of China
Find out more...Quantitative robust analysis and fine anti-interference control for multi-source interference nonlinear systems
National Natural Science Foundation of China
Find out more...Active Disturbance Rejection Controller Design for Series Elastic Actuators
National Natural Science Foundation of China
Find out more...Theory and experimental verification of anti-interference control for spacecraft full control loop
National Natural Science Foundation of China
Find out more...History
School
- Aeronautical, Automotive, Chemical and Materials Engineering
Department
- Aeronautical and Automotive Engineering
Published in
IEEE/CAA Journal of Automatica SinicaVolume
7Issue
3Pages
725 - 734Publisher
Institute of Electrical and Electronics Engineers (IEEE)Version
- AM (Accepted Manuscript)
Rights holder
© IEEEPublisher statement
© 2019 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.Acceptance date
2019-05-31Publication date
2019-09-30ISSN
2329-9266eISSN
2329-9274Publisher version
Language
- en