The effects of protective clothing and its properties on energy consumption during different activities

There are many situations where workers are required to wear personal protective clothing (PPC), to protect against a primary hazard, such as heat or chemicals. But the PPC can also create ergonomic problems and there are important side effects which typically increase with rising protection requirements. The most extensively studied side effect is that of increased heat strain due to reduced heat and vapour transfer from the skin. Less studied is the extra weight, bulk and stiffness of PPC garments which is likely to increase the energy requirements of the worker, reduce the range of movement and lead to impaired performance. Current heat and cold stress standards assume workers are wearing light, vapour permeable clothing. By failing to consider the metabolic effects of actual PPC garments, the standards will underestimate heat production and therefore current standards cannot be accurately applied to workers wearing PPC. Information on the effect of the clothing on the wearer and the interactions between PPC, wearer and environment is limited. Data was collected to quantify the effect of PPC on metabolic load based on the properties of the PPC for the EU THERMPROTECT project (GERD-CT-2002-00846). The main objective of the project was to provide data to allow heat and cold stress assessment standards to be updated so that they need no longer exclude specialised protective clothing. The aim of this thesis was to investigate the effect of PPC and its properties on energy consumption during work. For this purpose, the effects of a range of PPC garments (Chapter 3), weight (Chapter 4), number of layers and material friction (Chapter 5) and wet layers (Chapter 6) on energy consumption whilst walking, stepping and completing an obstacle course were studied. The impact of PPC on range of movement in the lower limbs was also investigated (Chapter 7). The main findings were; a) Increased metabolic cost of 2.4 - 20.9% when walking, stepping and completing an obstacle course in PPC compared to a control condition. b) An average metabolic rate increase of 2.7% per kg increase in clothing weight, with greater increases with clothing that is heavier on the limbs and in work requiring greater ranges of movement. c) 4.5 to 7.9% increase in metabolic cost of walking and completing an obstacle course wearing 4 layers compared to a single layer control condition of the same weight. d) Changes in range of movement in PPC due to individual behavioural adaptations. e) Garment torso bulk is the strongest correlate of an increased metabolic rate when working in PPC (r=0.828, p<0.001). f) Garment leg bulk (r=0.615), lower sleeve weight (r=0.655) and weight of the garment around the crotch (r=0.638) are also all positively correlated with an increased metabolic rate. Total clothing weight and clothing insulation had r values of 0.5 and 0.35 respectively. Background: Protective clothing (PPC) can have negative effects on worker performance. Currently little is known about the metabolic effects of PPC and previous work has been limited to a few garments and simple walking or stepping. This study investigated the effects of a wide range of PPC on energy consumption during different activities. Hypothesis: Wearing PPC would significantly increase metabolic rate, disproportionally to its weight, during walking, stepping and an obstacle course. Methods: Measuring a person’s oxygen consumption during work can give an indirect, but accurate estimate of energy expenditure (metabolic rate). Oxygen consumption was measured during the performance of continuous walking and stepping, and an obstacle course in 14 different PPC ensembles. Results: Increases in perceived exertion and in metabolic rate (2.4–20.9%) when wearing a range of PPC garments compared to a control condition were seen, with increases above 10% being significant (p<0.05). More than half of the increase could not be attributed to ensemble weight.