Thesis-1980-Jensen.pdf (15.54 MB)
Injection moulding variables and their influence on some properties of semi-crystalline polymers
thesisposted on 2017-11-13, 09:59 authored by Mogens Jensen
The present thesis is written according to the following sequence: first a literature review on injection moulding is presented, followed by an account of the influence from process variables on properties of mouldings; then follows a description of the instruments developed in relation to the project and used to characterize properties of mouldings; finally, a section gives an account of the following experimental work. [Continues.]
- Aeronautical, Automotive, Chemical and Materials Engineering
Publisher© Mogens Jensen
Publisher statementThis work is made available according to the conditions of the Creative Commons Attribution-NonCommercial-NoDerivatives 2.5 Generic (CC BY-NC-ND 2.5) licence. Full details of this licence are available at: http://creativecommons.org/licenses/by-nc-nd/2.5/
NotesA Doctoral Thesis. Submitted in partial fulfilment of the requirements for the award of Doctor of Philosophy at Loughborough University.