posted on 2014-03-31, 12:55authored byP.S. Newnham
In order to promote further understanding of the effects of the atmospheric environment
encountered by road vehicles in the real world, a wind tunnel based investigation was
conducted into the effect of small scale turbulence on the road vehicle optimisation
process. An initial investigation was carried out using a I-box model with variable
leading edge radii from 10mm to 100mm. Measurements of time averaged forces were
made over a range of Reynolds numbers from 200,000 to 1,300,000 (based on the
square root of frontal area) and free stream turbulence levels from 0.2% to 5.1%. The
transcritical Reynolds number based on edge radius was established as a basis for
comparison between turbulence levels. Centreline pressures and PlV vector fields are
presented to provide information on separation and reattachment. The investigation was
extended to a more representative 2-box model using the same radii as before and a
reference model at full scale, where the edge radii varied from 25mm to 150mm and
turbulence intensity from 1.8% to 4.3%. It was shown that there is a strong reduction of
separation under increased turbulence, and a small increase in skin friction.
A further experiment was carried out to investigate the influence of freestream
turbulence on the characteristic effect of changing backIight angle on lift and drag. It is
shown that there was a reduction in drag due to the action of turbulence on the
separation over the backIight, which may be driven by an effect on vortex strength.
Tests were also carried out on two full scale vehicles to investigate the effect of
increasing turbulence intensity on front and rear spoilers, cooling drag, and A-pillar
vortex flows. The observed changes were small but would often be cumulative in their
effect, so that optimising a vehicle in a significantly different turbulence level could
produce a difference in the total forces acting on the vehicle.
These experiments have shown that the primary effect of the additional freestream
turbulence introduced by grids is on the boundary layer, as was expected from the
literature. The results showed that increasing the turbulence intensity made separated
regions smaller, and suggested that vortices become weaker and less well defined. The
work provides a basis for continuing to investigate the effect of freestream turbulence
on the process of optimising the aerodynamics of road vehicles.
History
School
Aeronautical, Automotive, Chemical and Materials Engineering