Thesis-2013-Aremu.pdf (31.13 MB)
Topology optimization for additive manufacture
thesisposted on 2013-07-26, 12:29 authored by Adedeji Aremu
Additive manufacturing (AM) offers a way to manufacture highly complex designs with potentially enhanced performance as it is free from many of the constraints associated with traditional manufacturing. However, current design and optimisation tools, which were developed much earlier than AM, do not allow efficient exploration of AM's design space. Among these tools are a set of numerical methods/algorithms often used in the field of structural optimisation called topology optimisation (TO). These powerful techniques emerged in the 1980s and have since been used to achieve structural solutions with superior performance to those of other types of structural optimisation. However, such solutions are often constrained during optimisation to minimise structural complexities, thereby, ensuring that solutions can be manufactured via traditional manufacturing methods. With the advent of AM, it is necessary to restructure these techniques to maximise AM's capabilities. Such restructuring should involve identification and relaxation of the optimisation constraints within the TO algorithms that restrict design for AM. These constraints include the initial design, optimisation parameters and mesh characteristics of the optimisation problem being solved. A typical TO with certain mesh characteristics would involve the movement of an assumed initial design to another with improved structural performance. It was anticipated that the complexity and performance of a solution would be affected by the optimisation constraints. This work restructured a TO algorithm called the bidirectional evolutionary structural optimisation (BESO) for AM. MATLAB and MSC Nastran were coupled to study and investigate BESO for both two and three dimensional problems. It was observed that certain parametric values promote the realization of complex structures and this could be further enhanced by including an adaptive meshing strategy (AMS) in the TO. Such a strategy reduced the degrees of freedom initially required for this solution quality without the AMS.
IMCRC loughborough University
- Mechanical, Electrical and Manufacturing Engineering
Publisher© Adedeji Aremu
NotesA Doctoral Thesis. Submitted in partial fulfilment of the requirements for the award of Doctor of Philosophy of Loughborough University.